#How to smoke pipe tobacco in a glass bong how to#
#How to smoke pipe tobacco in a glass bong install#

#How to smoke pipe tobacco in a glass bong install#

As a consequence, you'll need to install a seal around its edge. Regardless of how good you are at lighting a bowl of water bottles, there's a strong possibility your shaft isn't entirely placed to the structure. This part of the pen should point downwards toward the water bottle's bottom, like tilting it down. If the gap was too small to fit the pen shaft through, quickly press the lighter against the plastic and try again. Since the plastic is now hot when you do this, it can mold fairly tightly around the pen shaft. When a small hole appears in the bottle due to the heat, quickly push the pen dowsteam through the hole.

Then, keep the flame of your lighter against the bottom third of the water bottle for a few seconds. Keep in mind you need to have the empty pen-pipe you just made on hand to do this properly. The next move is to make a small hole in the bottom third of the water bottle with a lighter, meaning two or three fingers up the end of it. Remove the cap and empty your water bottle. Toss away the remaining parts of the pen. Flip the metal shaft on top upside-down and firmly push the pointed end into the pen's shaft. Remove the ink tube and any other small parts (such as the spring) until you're left with only the pen's shaft and metal screw-on top. Unscrew the shaft and pop off the bottom bit with a butter knife. If that's not the case, please ensure it has a metal lid that can be unscrewed, that part that looks like a long bullet. Preferably, the pen you use should be made entirely of metal. You'll simply create a pen-pipe to complete this task. The bowl is the container where your marijuana is packed.Д¬reate the downstem of your bong before you do something else with your water bottle.The base is where the water sits and cools the smoke.The downstem is the narrower pipe that links the bowl to the water, allowing the smoke to pass down to the base and back up through the tube.The tube is the part of the bong where the smoke rises all the way to get into the lungs.The small hole on the bongвЂ™s side or back, known as the carb or carburetor, allows you to adjust the airflow with your index finger.

#How to smoke pipe tobacco in a glass bong how to#

To learn how to make a homemade bong successfully, you need to understand the structure and the basics of these simple devices.

A pen entirely made of metal or at least with a metal tip.

Smoking out of plastic is never a good idea because the heat from the smoke and the lighterвЂ™s heat will allow some of the plastic's substances to leach into your bloodstream. You will need plastic to build this bong and possibly a few of its individual components. Therefore, before we show you how to make a bong out of standard household products, you should know that this is not the healthiest way to consume cannabis. Nonetheless, we strongly advise you to make an investment and simply order a high-functioning model anyways. In reality, learning how to make a water bottle bong is an experience that any real stoner should have at least once in a lifetime, at the very least to mark it from your list. Today's DIY instructions will guide you through the process of making a homemade bong. Whatever the case may be, don't think too hard as we have the solution for your inconvenience. Have you left your bong behind at a friend's house? Maybe you never purchased one in the first place, you donвЂ™t have other alternatives, or perhaps you're just willing to try something new.